Vulcanising temperature and proto resin?
Hi..has anyone used a 3D print made with Solus proto resin to make a vulcanized rubber mold. What effect did the temperature have on the 3D print. I want to get some parts spun cast in zinc and wonder if the 3D print from proto resin will hold up to the temperature and pressure?
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Vulcanising temperature and proto resin?
There is the low heat rubber that should work fine. I don't think you go over 180 degrees to cure the rubber. Guys are curing the resin in a oven at 250.
-
- Novice
- Posts:17
- Joined:Tue Apr 26, 2016 5:14 pm
- Contact:
Re: Vulcanising temperature and proto resin?
I tried but I failed. Apparently I haven't been curing my models right to be used for vulcanized molds. Here's a tip Jordi gave me on how to cure:
clean with methanol first, IPA second clean, water with dish soap third, and finally water to get rid of the soap.
Then dry your model before puting it under the light, you can use a hair dryer, then let it cure on the UV lamp for a long time (4 to 6 hours depending on the model) make sure its completly cured ( it have to fil totaly dry).
I have yet to try this. If it doesn't I'll use cold silicone
clean with methanol first, IPA second clean, water with dish soap third, and finally water to get rid of the soap.
Then dry your model before puting it under the light, you can use a hair dryer, then let it cure on the UV lamp for a long time (4 to 6 hours depending on the model) make sure its completly cured ( it have to fil totaly dry).
I have yet to try this. If it doesn't I'll use cold silicone
Re: Vulcanising temperature and proto resin?
Here's an amazing ring by Nacho Riesco from a mold from the proto resin:
https://www.behance.net/gallery/4387891 ... Skull-Ring
https://www.behance.net/gallery/4387891 ... Skull-Ring
Re: Vulcanising temperature and proto resin?
Nice! I wonder if that is that cold enameling on the skull?
Re: Vulcanising temperature and proto resin?
Zakius wrote:Hi..has anyone used a 3D print made with Solus proto resin to make a vulcanized rubber mold. What effect did the temperature have on the 3D print. I want to get some parts spun cast in zinc and wonder if the 3D print from proto resin will hold up to the temperature and pressure?
I was asking the same thing in another thread. I wonder how hot the Proto resin can go.
Re: Vulcanising temperature and proto resin?
It can go hotter than the.emerald.
Who is online
Users browsing this forum: No registered users and 40 guests