Prestige investment
Here are some pics of a ring cast with the prestige investment from stuller. Made for resins. My first cast was not good, i parttialy cured it and didn't realize until i had invested it that i had not nuked it. Still came ok. This one is great. Followed their casting schedule.
Re: Prestige investment
Another pic
Re: Prestige investment
Having trouble posting pics
- M-Williams
- Solus Master
- Posts:393
- Joined:Sun Nov 01, 2015 4:45 pm
Re: Prestige investment
Beautiful Casting. Thank you for sharing.
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Prestige investment
Looks promising!
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Prestige investment
I've been using it also. I like it. You do have less time than Satincast for setup. I have had good results with resin and wax.
-
- Solus Expert
- Posts:197
- Joined:Wed Feb 17, 2016 10:36 pm
Re: Prestige investment
Is it better than Plasticast? I am about to run out of Plasticast and would like to try the Prestige if it is better.
Re: Prestige investment
I recive right now a bag of prestige, I switch from platicast. What burnout did you use for this investment? can I use the same ramps? The burnout official info for prestige looks very agresive.Thanks in advance.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: Prestige investment
I use my same burn out schedule.
Re: Prestige investment
Thank you Jewelermdt,
I was happy with Plasticast but in a few pieces with engravings I found loose investment parts and the engravings filled in.I tried add wter with boric with same result. Others came great. I hope to solve the problem with the new investment. By the way, I heard to burn the resins bottom up. Anyone tried it?
I was happy with Plasticast but in a few pieces with engravings I found loose investment parts and the engravings filled in.I tried add wter with boric with same result. Others came great. I hope to solve the problem with the new investment. By the way, I heard to burn the resins bottom up. Anyone tried it?
Who is online
Users browsing this forum: No registered users and 98 guests