Prints by Monger

Show off your prints.
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:
Re: Prints by Monger

Postby mongerdesigns » Wed Oct 24, 2018 11:18 pm

Cut them using micro scissors close to the surface. Then sand down what's left of the tip. If you make holes, you can also put a drop of resin into the hole, UV cure it, then sand it smooth.

That said, I also try orienting the models in such a way, that the supports are only attached to areas that are not so important, and also by using small supports in other areas.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
petertruong07
Posts:8
Joined:Fri Oct 20, 2017 2:40 am

Re: Prints by Monger

Postby petertruong07 » Thu Nov 01, 2018 4:23 am

very nice. How did you build the supports straight up.
Thanks
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Prints by Monger

Postby mongerdesigns » Thu Nov 01, 2018 5:59 pm

Peter, that's printed in multiple parts and put together.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Prints by Monger

Postby mongerdesigns » Fri Nov 02, 2018 11:55 pm

Model by a very talented artist, Hans Kristian Andersen (@hanska3d). Printed using SolusArt resin. Love this stuff. Around 75mm tall. 42 microns XY, 30 micron slices.

DSC_6595.JPG
DSC_6600.JPG
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/

Who is online

Users browsing this forum: No registered users and 8 guests