Home Cycle failure

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
dwolb
Posts:3
Joined:Fri Sep 30, 2016 1:56 pm
Home Cycle failure

Postby dwolb » Mon Feb 04, 2019 4:17 pm

While running home cycle printer make a loud growling/humming noise and continues to lower after hitting the stop switch. Will not rise without turning off power and manually turning the main screw. Have video if that helps.
User avatar
mongerdesigns
Solus Guru
Posts:1950
Joined:Sat Apr 25, 2015 5:16 pm
Location:Los Angeles
Contact:

Re: Home Cycle failure

Postby mongerdesigns » Mon Feb 04, 2019 5:09 pm

Could be the homing sensor. I suggest contacting support at info@junction3d.com
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com

Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com

Follow us on Instagram!
https://www.instagram.com/junction3d/

Who is online

Users browsing this forum: No registered users and 9 guests