This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
6 posts • Page 1 of 1
I think its a curing issue, but any advice will be appreciated.
- Solus Master
- Posts: 753
- Joined: Sun Jul 19, 2015 10:38 pm
- Location: N.W. Florida
Is that suppose to be one ring or single rings. The small opening between are causing problems. Investment breaking off. Tree is wrong. If they are separate rings, need more spacing between and feeder to each one.
It a small part that goes on top of a ring
What resin , what cure method ,what investment , what bur out ....
It was a curing issue. The lamp that i used for emerald was not curing the soluscast. Changed the curing unit and it perfect now. Thank you.
What were you using and what did you change to in order to get the better result?
Who is online
Users browsing this forum: No registered users and 4 guests