This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
- Posts: 35
- Joined: Wed Oct 24, 2018 9:55 pm
hasd81 wrote:I’m getting the same thing with my prints, same height every time.
Anyone solved this ????
- Posts: 24
- Joined: Sat Dec 29, 2018 10:38 am
If it is not your support or your film not being flat. You can also try and mount the Z-axis screw upside down. Then if it would have a bad spot it would be in a different location. Unless it is exactly in the middle.
- Posts: 2
- Joined: Fri Jan 12, 2018 9:26 pm
Did you ever figure out a fix for this? I have the same issue, but only with castable resins (emerald and soluscast). Art grey and solusproto work fine.
Who is online
Users browsing this forum: No registered users and 9 guests