How to fix this (streching?)?

This section is for specific instructions for daily operations of the Solus printer and for troubleshooting. User submitted tips, etc. should go in the "Tips and Tutorials" section.
Mikkopee
Novice
Posts:62
Joined:Mon Feb 13, 2017 1:18 pm
How to fix this (streching?)?

Postby Mikkopee » Thu Mar 26, 2020 5:24 am

Prongs are not round. Looks like streching?
prongs1.jpg


It should look like this:
prongs.jpg



This happens when using B9 Emerald and SolusCastPRO.
SolusProto works just fine.

Lamp about 1300h
B9 Exposure 7.5s @20
SolusCastPRO 7.5s @20

Is it exposure issue? Should I pump exposure more up?
Kokos
Novice
Posts:30
Joined:Sat Dec 29, 2018 10:38 am

Re: How to fix this (streching?)?

Postby Kokos » Thu Mar 26, 2020 1:33 pm

If it is in the Z direction it might be bleeding. Then you need to lower the exposure.
User avatar
Jewelermdt
Solus Master
Posts:809
Joined:Sun Jul 19, 2015 10:38 pm
Location:N.W. Florida
Contact:

Re: How to fix this (streching?)?

Postby Jewelermdt » Thu Mar 26, 2020 2:24 pm

Also getting close on hours to replace bulb.
Mikkopee
Novice
Posts:62
Joined:Mon Feb 13, 2017 1:18 pm

Re: How to fix this (streching?)?

Postby Mikkopee » Thu Mar 26, 2020 3:23 pm

Jewelermdt wrote:Also getting close on hours to replace bulb.

Yes I know. Just trying to get another 200h out of it :D

Who is online

Users browsing this forum: No registered users and 3 guests