First successful print at 25 micron
Re: First successful print at 25 micron
I put the piece in:
ultrasonic (water) 30s
ultrasonic (water + dishwashing soap) 30s
ultrasonic (IPA) 30s
Part was uncured upon taking pictures
ultrasonic (water) 30s
ultrasonic (water + dishwashing soap) 30s
ultrasonic (IPA) 30s
Part was uncured upon taking pictures
Re: First successful print at 25 micron
your support very tiny
Re: First successful print at 25 micron
Yes, they are, I haven't printed a large piece yet and found that this support seemed sufficient for all my iterations and testing with this ring. I've probably printed this same ring 3 times to get the results I want, mainly due to the elliptical shape of the first couple.
The support is done in b9c software with spike support. I found them to be very easy to break off while leaving little marks on the piece
The support is done in b9c software with spike support. I found them to be very easy to break off while leaving little marks on the piece
Re: First successful print at 25 micron
Good job - looks super smooth.
Re: First successful print at 25 micron
It is, I am very impressed with how smooth it is.
Who is online
Users browsing this forum: No registered users and 2 guests