Hello -
So my printer was about to print then an error popped up and now my build arm is stuck at Z. How do I get this think to move?
thanks, Kevin
Help!!! Build arm stuck at Z
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: Help!!! Build arm stuck at Z
Turn off the power from the switch in the back. Then by hand slowly turn the Z screw until you lift the arm enough so that you can slide the build table and tank out together. Reset everything, clean, and give it a go again.
Make sure to touch something metal before touching the printer. It's possible that static buildup caused the printer to disconnect from the USB. Try a different USB port and/or cable.
Make sure to touch something metal before touching the printer. It's possible that static buildup caused the printer to disconnect from the USB. Try a different USB port and/or cable.
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: Help!!! Build arm stuck at Z
thanks, everything seems to be working fine now.
kevin
kevin
Who is online
Users browsing this forum: No registered users and 18 guests