First print using SolusCast
Can't wait to cast!
Best Regards,
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
- mongerdesigns
- Solus Guru
- Posts:1950
- Joined:Sat Apr 25, 2015 5:16 pm
- Location:Los Angeles
- Contact:
Re: First print using SolusCast
Very nice!
Monger Designs a.k.a. Monger
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
http://www.mongerdesigns.com
Junction3d - Official US Distributor for the SOLUS 3D PRINTER
http://www.junction3d.com
Follow us on Instagram!
https://www.instagram.com/junction3d/
Re: First print using SolusCast
I am curious to see your casting outcome.
Engraving/lettering on a model makes for a tricky cast.
Please post a picture of your raw casting tree(good or bad).
Hope everything comes out perfect for you.
Engraving/lettering on a model makes for a tricky cast.
Please post a picture of your raw casting tree(good or bad).
Hope everything comes out perfect for you.
Re: First print using SolusCast
Impressive. I'd like to see the cast as well. Engravings are trouble for me.
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: First print using SolusCast
The big thing with engravings is to paint the recessed areas/lettering with investment before investing the flask. Let it set up just a little before investing in the flask.
-
- Novice
- Posts:47
- Joined:Thu Sep 29, 2016 8:01 pm
Re: First print using SolusCast
@Jewelermdt:
What did you mean with painting the letering with investment before investing the flask ?
Best regards from austria
What did you mean with painting the letering with investment before investing the flask ?
Best regards from austria
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: First print using SolusCast
I use an art paint brush to put investment into the lettering. you need to dab it in or air will get trapped. Let it set up a little before investing in flask. Something like that band, you might have to go over it a couple times. This is why you get fill in of metal. These little air bubbles don't get out with vacuum sometimes.
Re: First print using SolusCast
Great tip thank you. I did have a little trouble with the solus cast. Still trying to dial it in. I ended up regrowing it in the emerald green just to get it done.
Best Regards,
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
Luke Johnson
Senior Designer
Arthur's Jewelers Creations.
Other Custom Designs by Luke Johnson
Who is online
Users browsing this forum: No registered users and 28 guests