printer stuck during Homing circle
My printer during Homing circle once it's going down it stuck and. Some sound comes it's not going up. Why is that. I just tryed switch off and removed the divides and re connect. But the same why is that
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
- Jewelermdt
- Solus Master
- Posts:809
- Joined:Sun Jul 19, 2015 10:38 pm
- Location:N.W. Florida
- Contact:
Re: printer stuck during Homing circle
Sometimes I do a home with the vat still on printer. If it's too tight I will get a noise and it will stay down till I loosen the vat screws. So my guess would be the quartz is stuck, or a broken switch (BTDT) or as I just posted the other day, resin cure inside the tube of the homing pin.
Re: printer stuck during Homing circle
You use contour?
Try homing on CWS
Try homing on CWS
Re: printer stuck during Homing circle
solve it! i just pressed the reset button .
W.A Chamal .S .Jayaratna
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Jewelery CAD Designer
Jewellery Master model solution consultant
WEB - http://www.eoncadcam.com
Who is online
Users browsing this forum: No registered users and 9 guests